![]() ![]() Guide On Cutting and Polishing Rocks With A DremelĬutting rocks with a Dremel is more straightforward than many people think it is. You won’t be using sandpaper during this phase but you will be using a polishing compound made from some type of oxide or diamond. This is when you remove all of the fine scratches and you begin to see a mirror finish on the surface of the rock. The third and final phase is the polishing phase. The second phase I like to call the sanding phase because you’re still removing material but not as fast as the cutting phase (sandpaper grit should be 600 to 1200 range). The first phase will be the cutting phase and this is where you will use the most coarse sandpaper (the lower the number grit the more coarse the paper is). I like to break the process down into 3 phases. You’ll need a decent set of eyes, protective gear, a rock or gem with a Moh’s hardness of 5 or less, Dremel, bits and attachments, a polishing compound, and a diamond saw if you’re going to be cutting. Of course, there’s a bit more to the process, but we’ll get to that in a second. A polishing wheel is the second requirement.A sanding attachment that allows you to use different coarseness of sandpaper.You’ll need two attachments for polishing gems with a Dremel. Keep reading below to learn the basics of polishing rocks with a Dremel tool.Ī Dremel can do numerous tasks, and cutting and polishing stones are two of them. ![]() If you’re worried about not knowing how or where to start then you’ve come to the right spot. Polishing rocks with a Dremel is fairly easy and straightforward because most people have a Dremel at the house and if you don’t then you can pick one up online or at the hardware store.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |